Power equipment service in Ontario is one of the most overlooked forms of preventive maintenance, and one of the most consequential. A lawn mower, chainsaw, or generator that hasn't been properly serviced doesn't just underperform. It fails, and almost always at the worst possible time.
At The Power Garage in Woodstock, our Husqvarna-authorized technicians service all brands of outdoor power equipment, from zero turn mowers and robotic mowers to chainsaws, trimmers, and generators. We handle routine tune-ups, seasonal preparation, warranty service, and repairs, with a full parts department on-site for fast turnaround.
Serving Woodstock, Oxford County, London, Brantford, Kitchener, and all of southwestern Ontario.
Ready to book? Schedule your power equipment service online, or browse our power equipment inventory if you are considering an upgrade.
A proper small engine tune-up is more than swapping a spark plug. It is a systematic inspection and service of every component that affects starting, running, and long-term reliability. Here is what our technicians cover on a complete power equipment service:
| System | What We Service | Why It Matters |
|---|---|---|
| Engine | Spark plug inspection or replacement; compression test; valve clearance check (where applicable) | A worn or incorrect spark plug is the single most common cause of hard starting in small engines |
| Fuel System | Carburettor clean or rebuild; fuel filter replacement; fuel lines inspection; primer bulb check | Ethanol in Ontario pump fuel degrades rubber components and gums carburettors; annual fuel system service is essential |
| Air Filter | Air filter inspection and replacement | A clogged air filter starves the engine of oxygen, causes poor running, excessive fuel consumption, and premature wear |
| Oil System | Engine oil drain and refill; oil filter replacement (where applicable) | Old oil loses its viscosity and lubrication properties, especially in equipment that runs hot |
| Cutting System | Blade sharpening, balance, and torque check (mowers); chain sharpening and tension (chainsaws); trimmer head and line | Dull blades tear grass rather than cutting it cleanly, damage the lawn, and stress the engine |
| Drive System | Belt and cable inspection; drive engagement; deck levelness (riding mowers); wheel and axle check | Drive system wear is gradual; catching it before failure avoids costly mid-season breakdowns |
| Electrical | Battery condition and charge; starter function; safety switches; charging circuit (where applicable) | Electrical failures are the most common cause of equipment that cranks but won't start |
| Exterior & Safety | Deck wash; lubrication of pivot points; safety guard inspection; handle and control check | Clean equipment runs cooler and lasts longer; safety guard inspection is non-negotiable |
The single most preventable power equipment failure in Ontario is ethanol-related fuel system damage. Ethanol-blended pump fuel begins to degrade in as little as 30 days. Running old fuel through a carburettor, or storing equipment with untreated fuel, is the leading cause of the carburettor rebuilds and fuel system repairs we see every spring. Fuel stabilizer added at the end of every season eliminates this.
| Equipment Type | Recommended Service Timing |
|---|---|
| Lawn mower (push and self-propelled) | Annually — ideally spring before first use, or fall before storage |
| Zero turn mower | Every 50–100 hours or annually — more frequently under heavy use conditions |
| Robotic mower (Husqvarna Automower) | Annually — blade replacement every 1–2 months during season; full service each fall |
| Chainsaw | Annually or every 25 hours of cutting — chain sharpening as needed throughout season |
| String trimmer / brushcutter | Annually — spring start-up service recommended after storage |
| Generator | Annually — service before storage season; test run every 3 months if stored long-term |
| Pressure washer | Annually — pump oil and nozzle inspection; winterization before freezing temperatures |
In Oxford County and across southwestern Ontario, the two most important service windows for power equipment are spring and fall. Equipment that is properly prepared at the end of one season is equipment that starts reliably at the beginning of the next.
Use this as a reference guide for your own scheduling, or bring your equipment in and our technicians will handle it for you.
| Month | Season | Key Tasks |
|---|---|---|
| March | Early spring | Book spring service appointments; slots fill quickly. Pull equipment from storage and assess condition. |
| April | Spring start-up | Full tune-up for mowers, trimmers, and chainsaws. Fresh oil, new spark plug, air filter, sharpen blades and chains. Check fuel system. |
| May | Peak season | First use of the season. Check tire pressure (riding mowers), inspect belts and cables. Confirm Automower boundary wire and charging station. |
| June–August | Active season | Monitor air filter every 8–10 hours in dusty conditions. Sharpen mower blades monthly or as needed. Chain sharpening every 2–3 sessions for chainsaws. |
| September | Early fall | Assess equipment for any in-season wear. Replace Automower blades if not done. Book fall storage service. |
| October | Fall storage prep | Add fuel stabilizer and run engine for 5 minutes. Final oil change while warm. Clean decks, guards, and exterior. Lubricate all pivot points. |
| November | Storage | Remove batteries and store indoors. Drain fuel from 2-stroke equipment. Cover and store in dry location. Generator: run on stabilized fuel; drain carburettor. |
| December–February | Off-season | Equipment in storage. Ideal time to schedule spring service in advance; booking early guarantees your preferred appointment slot. |
Use this checklist when preparing equipment for spring or fall. Bring it in with your equipment at service time and our technicians will work through it with you.
| Equipment | Task | Tech Note |
|---|---|---|
| Mower (all types) | Change engine oil and filter | Do this before first use — old oil from storage contains combustion acids |
| Mower (all types) | Replace spark plug | New plug every season ensures clean, reliable starting |
| Mower (all types) | Replace or clean air filter | A clogged filter from storage will cause rough running immediately |
| Mower (all types) | Sharpen and balance blade(s) | Dull blades tear grass — balance prevents spindle bearing damage |
| Riding / Zero Turn | Inspect and adjust drive belt | Belt stretch and cracking develops over storage |
| Riding / Zero Turn | Check tire pressure and condition | Tires lose pressure in cold storage — inspect for sidewall cracking |
| Chainsaw | Sharpen or replace chain | A dull chain causes kickback risk and engine overload |
| Chainsaw | Check chain tension and bar condition | Loose chain and worn bar reduce cutting performance and safety |
| Chainsaw | Clean air filter and inspect fuel lines | Fuel line cracking is common after winter storage |
| Generator | Test start and run for 15 minutes under load | Confirms engine health before you need it in an emergency |
| Generator | Check oil level and replace if overdue | Generators in storage should have oil changed before use |
| Trimmer / Brushcutter | Replace fuel lines and primer bulb if cracked | Rubber degrades in storage — inspect before fuelling |
| Automower | Replace cutting blades (if not done in fall) | Blades dull over a season — start fresh for best cutting quality |
| Automower | Inspect boundary wire and charging contacts | Frost heave can displace wire; contacts corrode over winter |
| Equipment | Task | Tech Note |
|---|---|---|
| All equipment | Add fuel stabilizer to tank and run engine 5 minutes | Treats the entire fuel system — prevents gum and varnish buildup |
| All equipment | Final oil change while engine is warm | Warm oil drains completely — removes combustion acids before storage |
| All equipment | Clean exterior, deck, and guards thoroughly | Debris holds moisture — causes rust and accelerates wear during storage |
| All equipment | Lubricate all pivot points, cables, and controls | Prevents seizing and corrosion during long storage |
| Mower (all types) | Remove and inspect battery; store indoors | Batteries discharge in cold — storing indoors preserves capacity |
| Riding / Zero Turn | Disengage deck and check blade bolts | Secure all fasteners before storage to prevent rattling and loosening |
| Chainsaw | Drain bar oil and empty fuel tank (2-stroke) | 2-stroke fuel degrades quickly — drain or stabilize before storage |
| Chainsaw | Clean bar groove and remove chain for storage | Prevents bar and chain from corroding or seizing together |
| Generator | Run on stabilized fuel then drain carburettor | Stabilize the tank; drain the carb to prevent varnishing |
| Generator | Check and top up oil | Fresh oil prevents internal corrosion during storage |
| Automower | Replace cutting blades before storing | Start next season fresh — blades are inexpensive; labour is not |
| Automower | Clean chassis and charging contacts; store in garage | Automowers are not designed for outdoor winter storage |
Fall storage service should be completed before temperatures in Oxford County regularly drop below 5°C, typically late October to early November. Do not store equipment with old, unstabilized fuel over winter. Booking in September secures your preferred appointment slot before the October rush.
The Power Garage is an authorized Husqvarna dealer and service centre in Woodstock, Ontario. That authorization means more than a badge on the wall; it means our technicians are trained to Husqvarna's specific service standards, have access to Husqvarna diagnostic tools, and use genuine Husqvarna parts for warranty and post-warranty service alike.
| Benefit | What It Means in Practice |
|---|---|
| Warranty protection | Husqvarna warranty service must be completed by an authorized dealer to remain valid. Using an unauthorized shop for warranty work can result in a denied claim. |
| Genuine OEM parts | Authorized dealers use Husqvarna OEM parts, blades, belts, filters, and components engineered to exact fit and performance specifications. |
| Model-specific training | Husqvarna's product range is broad, from robotic mowers to professional chainsaws and zero turns. Our technicians are trained on the specific service requirements of each product line. |
| Diagnostic access | Authorized dealers have access to Husqvarna's diagnostic software for robotic mowers and connected equipment, tools that independent shops cannot access. |
| All brands accepted | Authorization does not limit who we service. We work on all power equipment brands, Husqvarna, Briggs & Stratton, Honda, Kohler, and more. Our OEM expertise transfers across all small engine service. |
Husqvarna equipment under warranty must be serviced by an authorized dealer to maintain coverage. This applies to Automower robotic mowers, zero turn mowers, chainsaws, and all other Husqvarna products. If your equipment is within the warranty period, contact our service desk before taking it to an independent shop; unauthorized service can void your coverage.
Need a Husqvarna part or replacement blade? Visit our parts department; we carry genuine Husqvarna OEM parts and consumables and can order what we don't have on the shelf.
Thinking about upgrading your equipment? Browse our power equipment inventory, including Husqvarna zero turn mowers, robotic mowers, chainsaws, and outdoor power equipment available in Woodstock, Ontario.
Whether it's an annual tune-up, spring start-up service, fall storage preparation, or a repair, our Husqvarna-authorized technicians are ready. We service all outdoor power equipment brands, not just Husqvarna.
Serving Woodstock, Oxford County, London, Brantford, Kitchener, and all of southwestern Ontario. On-site parts department with Husqvarna OEM parts and components for all major brands.
Husqvarna-authorized technicians · All brands welcome · Woodstock, Ontario
Considering new equipment? Ask our team about current Husqvarna inventory; we carry zero turn mowers, robotic mowers, chainsaws, trimmers, and more.